The Chart Designer allows you to set up the most commonly used of the chart settings. However Reportal also has a large number of additional chart properties...

The Advanced Properties > General tab holds the properties that apply to the entire chartClick on the properties in the figure below for further details, and...

The Chart Area tab contains the properties that specify the look and layout of the chart area. The properties in the Chart Area tab are divided amongst six t...

The 3D Style tab contains those properties that control the 3-dimensional functionality. The tab contains three settings that are not described in the Chart ...

Charts in Forsta Reportal normally use one X axis and one Y axis. Settings for these two axes are normally found under “Primary X-axis” and “Primary Y-axis”....

 This tab contains the properties for formatting and displaying the chart legend. Note that the majority of the properties are also available via the Chart D...

Use the properties on this tab to set up the chart borders for this chart. Note that if you want all the charts in your report to use the same border skin, t...

The properties contained in the Row Content and Column Content tabs are identical, so are described only once.On the Category Masking tab (see the figure bel...

If you wish the size of the chart to vary depending on the content in the table it is based on, use the Proportional Size settings. These settings reduce the...

This function enables you to add animation to your charts. The properties described here are also accessible via the Chart Designer > Animation tab (go to An...